EASYJOINT™ 60 Setting Type Premium Jointing Powder

EASYJOINT™ 60 Setting Type Premium Jointing Powder
Consistent setting time
Mixes easily to a smooth and creamy gauge
Easy scrape back
Excellent joint filling with excellent adhesion, high strength and low shrinkage
EASYJOINT™ 60 Setting Type Premium Jointing Powder application
Surfaces must be clean and free from dust
The use of paper tape is recommended such as USG Middle East Paper Joint Tape
Ensure there is sufficient amount of compound under the paper tape to provide adhesion
First Coat (150mm wide)
Using a broad knife, evenly fill the joint recess formed by the edges of the gypsum board with EASYJOINT™ 60 Setting-Type Premium-Jointing Powder
Center paper tape along the joint and press into the compound using the broad knife
Draw the broad knife at a 45° angle along the joint with enough pressure to remove excess compound and any air bubbles caught beneath the tape. Leave enough compound under the tape to provide a strong bond
Apply a thin layer of compound over the tape to prevent the tape edge curling and cracking. Feather the compound from the edges outwards. Cover all fastener heads with spots of compound
Second Coat (200mm wide)
When dry, apply a second coat using a plasterer’s trowel, approximately 50mm wider than the first coat. Spot fastener heads again. Allow to dry
When the second coat has dried, scrape or sand back any excess compound for a smooth and level surface
Third Coat (250mm wide)
Apply a finishing coat of compound with a trowel, approximately 50mm wider than the previous coat
When dry, using 180 to 220 grit sandpaper in a hand sander, sand lightly to a smooth finish, taking care not to scuff the surrounding gypsum board
Thoroughly clean all tools and equipment after use

View original product page